Everglades 230 T-Top Boat Cover — Custom-Fit for the 23’7″ Everglades 230 CC
Everglades Boats builds in Edgewater, Florida; it was founded in 1997 by Bob Dougherty, the former Boston Whaler designer who had earlier started EdgeWater, and it molds every hull with its patented RAMCAP process, which bonds the fiberglass hull and liner around a pre-molded closed-cell urethane foam core. The 230 CC is Everglades’ 23-foot family-and-fishing center console, with listings from 2009 and factory spec sheets through the 2017 model year. The 2017 sheet gives it 23’7″ without the engine (24 feet with it), an 8’6″ beam, a 15-inch hull draft, about 3,800 lb without the engine (HMY lists 4,300 lb), 108 to 112 gallons of fuel and a single outboard of up to 300 hp, on a hull with 19 degrees of deadrise at the transom and 36 degrees on average. The fiberglass hardtop on a powder-coated aluminum frame is standard, with LED and spreader lights, an electronics box, four rod holders and a ski pylon, over Everglades’ patented sliding windshield; bridge clearance is 7’7″ with the top. Underneath, a cover has to clear the console with its head compartment and cushioned forward seat, the combination helm seat/leaning post, U-shaped bow seating with a sun-deck insert, a split stainless bow rail, stern seats that fold into a casting platform and two swim platforms flanking the outboard. This T-Top cover is patterned for the 230 CC with its hardtop, and like all of our Everglades boat covers, it’s cut to this hull rather than a generic 23-foot size chart.
How It Fits the 230
The cover runs up to the underside of the hardtop and wraps the frame legs, leaving the roof, electronics box and rod holders exposed. Below, it drapes over the windshield, console and leaning post, spreads forward over the forward console seat, sun-deck insert and U-shaped bow seating to the split bow rail, and falls to the rubrail along the 8’6″ beam. Aft, it covers the folding stern seats and both swim platforms and encloses the outboard in the same piece. Installation takes about five minutes: drape it bow to stern, run the hem cord along the rubrail, and cinch the adjustable strap-and-buckle tie-downs. It’s made for storage on a trailer, lift, dry stack, or jet dock — take it off before towing, since trailering with the cover on can damage it and voids the warranty.
Hardtop or No Top?
This T-Top cover is for a 230 with the hardtop, which was standard. Everglades also offered a hardtop delete, and built the 230 DC dual console on the same 23’7″ length and 8’6″ beam; if your boat has no hard top, see our Everglades 230 DC cover, a full-boat style that goes over everything.
Fabric, Warranty & Shipping
Choose 9oz solution-dyed marine fabric for heavy-duty everyday protection (5–7 year service life), a lighter 7oz fabric for budget-friendly coverage, or premium Sunbrella acrylic for 8–10 years of fade resistance. Every option is water-repellent, breathable, mildew-resistant, and double-stitched at the seams. Each cover is backed by our warranty (1 year on materials and workmanship, plus 3–6 years on the fabric) and ships for a $30 flat rate within the US — every cover is made to order, so please allow 1–3 weeks. For the newer 23-foot model, see the Everglades 235 CC T-Top cover.
