Edgewater 248 CX T-Top Boat Cover — Custom-Fit for the EdgeWater 248CX Dual-Console Crossover
EdgeWater Power Boats builds its boats in Edgewater, Florida; the company was founded in 1992 by Bob Dougherty, formerly chief designer and head of engineering at Boston Whaler, and molds its hulls with a closed-mold, vacuum-infused process it calls Single Piece Infusion. The 248CX is EdgeWater’s 24-foot crossover — a deep-V dual console built to run on a single outboard. It was introduced at the 2016 Palm Beach show as an improvement on the earlier 245CX and remains in the current lineup. EdgeWater gives it 24’6″ overall, an 8’6″ beam, a 21-inch draft, 5,950 lb, 120 gallons of fuel and up to 350 hp, with a Yamaha F300 as the standard engine. A white powder-coated fiberglass hardtop with two LED spreader lights is standard, with rod holders and an enclosure optional, over a tempered-glass windshield. The port console holds a walk-in head with a skylight and the starboard console holds the helm, with an adjustable helm seat and flip bolster. Behind them, the cockpit has a port-side Ultra Lounger with six seating positions, a starboard prep station with a sink and 50-quart cooler, and a full-width folding transom seat beside the walk-through door and 28-gallon baitwell; the bow has lounge seating with armrests over insulated fishboxes. This T-Top cover is patterned for the 248CX with its hardtop, and like all of our Edgewater boat covers, it’s cut to this hull rather than a generic 24-foot size chart.
How It Fits the 248CX
The cover runs up to the underside of the hardtop and wraps its supports, leaving the roof exposed. Below, it drapes over the windshield and both consoles, spreads forward over the bow lounge to the rubrail along the 8’6″ beam, and continues aft over the lounger, prep station and transom seat to enclose the outboard in the same piece. Installation takes about five minutes: drape it bow to stern, run the hem cord along the rubrail, and cinch the adjustable strap-and-buckle tie-downs. It’s made for storage on a trailer, lift, dry stack, or jet dock — take it off before towing, since trailering with the cover on can damage it and voids the warranty.
Dual Console, T-Top Style
We call this a T-Top cover because that is our style for any boat with a hard top: it fits up under the 248CX’s hardtop instead of going over it. The 248CX shares its 24’6″ length and 8’6″ beam with the 245 CC center console, but the dual-console windshield and seating give it a different shape, so each has its own pattern.
Fabric, Warranty & Shipping
Choose 9oz solution-dyed marine fabric for heavy-duty everyday protection (5–7 year service life), a lighter 7oz fabric for budget-friendly coverage, or premium Sunbrella acrylic for 8–10 years of fade resistance. Every option is water-repellent, breathable, mildew-resistant, and double-stitched at the seams. Each cover is backed by our warranty (1 year on materials and workmanship, plus 3–6 years on the fabric) and ships for a $30 flat rate within the US — every cover is made to order, so please allow 1–3 weeks. For the 24-foot center console, see the Edgewater 245 T-Top cover; for EdgeWater’s larger crossover, the Edgewater 262 CX T-Top cover.
