Everglades 240 T-Top Boat Cover — Custom-Fit for the 24’7″ Everglades 240 CC
Everglades Boats builds in Edgewater, Florida; it was founded in 1997 by Bob Dougherty, the former Boston Whaler designer who had earlier started EdgeWater, and it molds every hull with its patented RAMCAP process, which bonds the fiberglass hull and liner around a pre-molded closed-cell urethane foam core. The 240 CC is Everglades’ wide-beam 24-foot offshore center console from the mid-2000s; BoatTest lists it from 2007 and it is no longer in production. Boating’s test gives it 24’7″ overall, a 9’3″ beam, about 4,000 lb without power and 163 gallons of fuel, on a hull with 21 degrees of deadrise at the transom; power was a single 225 hp Honda as standard or twin 150s, and BoatTest ran one with twin 200s. A powder-coated T-top was standard, with a fiberglass hardtop in gelcoat colors as an option, over an electric windshield that slides down at the push of a button. Under the top, a cover has to clear the console with its electric porcelain head, a leaning-post workstation with a 45-gallon livewell and sink, bolster helm seats on flip-down bases, a 104-quart cooler seat in front of the console, bow cushions over a 129-gallon fishbox, low-profile powder-coated bow rails and an anchor windlass, a folding stern seat and a lockable transom gate. This T-Top cover is patterned for the 240 CC with its T-top or hardtop, and like all of our Everglades boat covers, it’s cut to this hull rather than a generic 24-foot size chart.
How It Fits the 240
The cover runs up to the underside of the top and wraps its legs, leaving the roof and any outrigger bases exposed. Below, it drapes over the windshield, console and leaning-post workstation, carries forward over the cooler seat and cushioned bow to the low rails, and falls to the rubrail along the 9’3″ beam — almost nine inches wider than most 24-footers. Aft, it covers the folding stern seat and transom gate and encloses a single outboard or twin outboards in the same piece. Installation takes about five minutes: drape it bow to stern, run the hem cord along the rubrail, and cinch the adjustable strap-and-buckle tie-downs. It’s made for storage on a trailer, lift, dry stack, or jet dock — take it off before towing, since trailering with the cover on can damage it and voids the warranty.
240 or 243?
The numbers are close, but the 243 CC is a different boat: a narrower 8’2″ bay-and-offshore hybrid with a standard fiberglass hardtop. The 240 is the wide 9’3″ offshore hull, so each has its own pattern. If your model number reads 243, choose the Everglades 243 T-Top cover.
Fabric, Warranty & Shipping
Choose 9oz solution-dyed marine fabric for heavy-duty everyday protection (5–7 year service life), a lighter 7oz fabric for budget-friendly coverage, or premium Sunbrella acrylic for 8–10 years of fade resistance. Every option is water-repellent, breathable, mildew-resistant, and double-stitched at the seams. Each cover is backed by our warranty (1 year on materials and workmanship, plus 3–6 years on the fabric) and ships for a $30 flat rate within the US — every cover is made to order, so please allow 1–3 weeks. For the later wide-beam 25-footer, see the Everglades 250 T-Top cover.
