Everglades 250 T-Top Boat Cover — Custom-Fit for the Wide-Beam Everglades 250 CC
Everglades Boats builds in Edgewater, Florida; it was founded in 1997 by Bob Dougherty, the former Boston Whaler designer who had earlier started EdgeWater, and it molds every hull with its patented RAMCAP process, which bonds the fiberglass hull and liner around a pre-molded closed-cell urethane foam core. The 250 CC is Everglades’ wide-beam 25-foot offshore center console; we found its factory sheet for the 2013 model year. It rides on a 9’3″ beam with a variable-deadrise deep-V hull and carries 163 gallons of fuel — the same beam and tank size as the earlier 240 CC — and it’s rigged with twin outboards of 200 or 225 hp each, or a single 350. The fiberglass hardtop on a powder-coated aluminum frame is standard, with LED and spreader lights, an electronics box, five rod holders and two speakers, over an electric sliding windshield; a three-sided enclosure and a crow’s nest were options. Under the top, a cover has to clear the console with its china-bowl head, helm seating with bolsters that converts to a leaning post, a 94-quart cooler seat with backrest at the console front, U-shaped bow seating over a 129-gallon fishbox, low-profile powder-coated bow rails and an anchor windlass, a stern seat that lifts for battery access and a lockable transom gate. This T-Top cover is patterned for the 250 CC with its hardtop, and like all of our Everglades boat covers, it’s cut to this hull rather than a generic 25-foot size chart.
How It Fits the 250
The cover runs up to the underside of the hardtop and wraps the frame legs, leaving the roof, rod holders and any outriggers or crow’s nest exposed; take a weather enclosure off first. Below, it drapes over the windshield, console and helm seating, spreads forward over the cooler seat and U-shaped bow seating to the low rails, and falls to the rubrail along the 9’3″ beam. Aft, it covers the stern seat and transom gate and encloses twin outboards, or a single, in the same piece. Installation takes about five minutes: drape it bow to stern, run the hem cord along the rubrail, and cinch the adjustable strap-and-buckle tie-downs. It’s made for storage on a trailer, lift, dry stack, or jet dock — take it off before towing, since trailering with the cover on can damage it and voids the warranty.
250 or 253?
Despite the similar numbers, the 253 CC is a different boat — a 24’9″ hybrid on a narrower 8’6″ beam with a hardtop mounted to the console. The 250’s 9’3″ beam needs its own pattern, so check the model number on your hull paperwork; for a 253, choose the Everglades 253 T-Top cover.
Fabric, Warranty & Shipping
Choose 9oz solution-dyed marine fabric for heavy-duty everyday protection (5–7 year service life), a lighter 7oz fabric for budget-friendly coverage, or premium Sunbrella acrylic for 8–10 years of fade resistance. Every option is water-repellent, breathable, mildew-resistant, and double-stitched at the seams. Each cover is backed by our warranty (1 year on materials and workmanship, plus 3–6 years on the fabric) and ships for a $30 flat rate within the US — every cover is made to order, so please allow 1–3 weeks. For the earlier 9’3″ beam model, see the Everglades 240 T-Top cover.
