Everglades 230 DC Center Console Boat Cover — Custom-Fit for the Everglades 230 DC Dual Console
Everglades Boats builds in Edgewater, Florida; it was founded in 1997 by Bob Dougherty, the former Boston Whaler designer who had earlier started EdgeWater, and it molds every hull with its patented RAMCAP process, which bonds the fiberglass hull and liner around a pre-molded closed-cell urethane foam core. The 230 DC is Everglades’ 23-foot dual console, built from about 2012 to 2016 according to HMY, for fishing, skiing and cruising. The 2015 factory sheet gives it 23’7″ without the engine (24 feet with it), an 8’6″ beam, a 15-inch hull draft, about 3,800 lb without the engine, 108 to 112 gallons of fuel and a single outboard of up to 300 hp, on a hull with 19 degrees of deadrise at the transom and 36 on average — the same figures Everglades lists for its 230 CC. It has two consoles — a starboard helm with a custom helm chair and a port console with a head compartment — joined by a tempered-glass windshield with frameless forward glass and integrated handrails. Other features a cover has to clear include a passenger seat on a 360-degree swivel base, bow seating with storage, an anchor locker with a stainless roller, stern seats that fold into a casting platform, and two swim platforms flanking the outboard. This full-boat cover is patterned for a 230 DC without a hard top, and like all of our Everglades boat covers, it’s cut to this hull rather than a generic 23-foot size chart.
How It Fits the 230 DC
The windshield is the high point: the cover peaks over the two consoles and the glass between them, then slopes forward over the bow seating and aft over the helm chair, passenger seat and stern seats to the rubrail along the 8’6″ beam, so rain runs off instead of pooling. At the stern it wraps the outboard in the same piece; trim the motor down first. Installation takes about five minutes: drape it bow to stern, run the hem cord along the rubrail, and cinch the adjustable strap-and-buckle tie-downs. It’s made for storage on a trailer, lift, dry stack, or jet dock — take it off before towing, since trailering with the cover on can damage it and voids the warranty.
About the Arch
The 230 DC’s standard equipment includes a powder-coated aluminum arch carrying a canvas sun-top, rod holders, a ski pylon and outrigger mounts, and Everglades offered an arch delete. This cover is for a 230 DC with no hard top over the cockpit. If your boat has the arch, contact us before ordering so we can confirm the fit for your setup; if a hardtop has been added, our T-Top style is the one that fits under it.
Fabric, Warranty & Shipping
Choose 9oz solution-dyed marine fabric for heavy-duty everyday protection (5–7 year service life) or premium Sunbrella acrylic for 8–10 years of fade resistance. Both are water-repellent, breathable, mildew-resistant, and double-stitched at the seams. Each cover is backed by our warranty (1 year on materials and workmanship, plus 5 years on 9oz and 6 years on Sunbrella) and ships for a $30 flat rate within the US — every cover is made to order, so please allow 1–3 weeks. For the single-console 230 with its hardtop, see the Everglades 230 T-Top cover; for the newer 23-footer, the Everglades 235 CC T-Top cover.
