Cast & Blast 22 Kings Bay T-Top Boat Cover — Custom-Fit for the 22-Foot Aluminum Bay Boat
The Cast & Blast 22 Kings Bay is the 22-foot aluminum bay boat from Cast and Blast Boats of Charleston, South Carolina — the small Lowcountry builder founded by aluminum fabricator Brooks Oswald, best known for its welded-aluminum 17CC flats skiff. Local anglers reported in early 2017 that Oswald had a 22-foot aluminum bay boat prototyped, and the Kings Bay 22 boats we have seen on the resale market are 2018 and 2019 models. Cast and Blast does not publish a spec sheet for the 22 on its current website, so the figures here come from used-boat listings: 22 feet long, a beam of about 8’6″ (listed as 2.59 m), an aluminum hull, and a single outboard — one 2019 boat was rigged with a Suzuki 200 hp. It is a center console layout, with the console amidships, open fishing room forward and a cockpit aft to the transom-mounted engine. This T-Top cover is patterned for the Cast & Blast 22 Kings Bay with its T-top, and like all of our Cast & Blast boat covers, it’s cut to this hull rather than a generic 22-foot size chart.
How It Fits the Cast & Blast 22 Kings Bay
The cover runs up to the underside of the T-top and is cut to wrap around the frame legs, so the T-top roof stays exposed while everything below it is covered. From there it drapes over the console, helm seating and leaning post, out to the gunwales, forward over the bow deck, and aft over the cockpit and the single outboard as one piece. Because an 8’6″ beam is full width for a 22-footer, the pattern follows that beam down to the rubrail instead of relying on stretch the way a universal bay-boat cover does. Kings Bay boats were built in small numbers and many are rigged to the owner’s order, so if your T-top frame, poling platform, or tower is different from a standard center-console T-top, contact us before ordering. On a boat this size, installing is easiest with two people: drape it bow to stern, run the hem cord along the rubrail, and cinch the adjustable strap-and-buckle tie-downs. It’s made for storage on a trailer, lift, dry stack, or jet dock — take it off before towing, since trailering with the cover on can damage it and voids the warranty.
Not the Same as the 17 Flats
Cast and Blast’s better-known boat is the 17-foot flats skiff, a much smaller, narrower hull (17 feet with a 72-inch beam) that is normally run without a T-top. Our two Cast & Blast patterns are not interchangeable — check the length on your hull or registration before ordering.
Fabric, Warranty & Shipping
Choose 9oz solution-dyed marine fabric for heavy-duty everyday protection (5–7 year service life), a lighter 7oz fabric for budget-friendly coverage, or premium Sunbrella acrylic for 8–10 years of fade resistance. Every option is water-repellent, breathable, mildew-resistant, and double-stitched at the seams. Each cover is backed by our warranty (1 year on materials and workmanship, plus 3–6 years on the fabric) and ships for a $30 flat rate within the US — every cover is made to order, so please allow 1–3 weeks. If you also run the builder’s smaller skiff, see our Cast & Blast 17 Flats Center Console cover.
