Everglades 210 T-Top Boat Cover — Custom-Fit for the 21’7″ Everglades 210 CC
Everglades Boats builds in Edgewater, Florida; it was founded in 1997 by Bob Dougherty, the former Boston Whaler designer who had earlier started EdgeWater, and it molds every hull with its patented RAMCAP process, which bonds the fiberglass hull and liner around a pre-molded closed-cell urethane foam core. The 210 CC joined the lineup for 2007, replacing the 211 CC, according to Soundings’ 2008 test, and listings run to at least the 2014 model year. It measures 21’7″ overall with an 8’6″ beam and a 15-inch draft, weighs about 3,600 lb without the engine, and carries 95 gallons of fuel on a deep-V with 21 degrees of deadrise at the transom; the factory sheet offers single outboards from 200 to 300 hp. On the boat Soundings tested, the T-top was a vertical top mounted to the console rather than the deck, with sliding windshield panels; later sheets list a fiberglass hardtop on an aluminum frame with an electronics box and four rod holders as an option, with a canvas sun top as the alternative. Under the top, a cover has to clear the console with its head compartment and forward console seat, a helm seat/leaning post with a folding footrest, the bow casting platform with its sun-pad insert and seating, stern seats that fold into a casting platform, and twin swim platforms either side of the outboard. This T-Top cover is patterned for the 210 CC with its T-top or hardtop, and like all of our Everglades boat covers, it’s cut to this hull rather than a generic 21-foot size chart.
How It Fits the 210
The cover runs up to the underside of the top and wraps its supports, leaving the roof, electronics box and rod holders exposed. Below, it drapes over the windshield, console and leaning post, carries forward over the forward console seat and the raised bow platform, and falls to the rubrail along the 8’6″ beam. Aft, it covers the folding stern seats and both swim platforms and encloses the outboard in the same piece. Installation takes about five minutes: drape it bow to stern, run the hem cord along the rubrail, and cinch the adjustable strap-and-buckle tie-downs. It’s made for storage on a trailer, lift, dry stack, or jet dock — take it off before towing, since trailering with the cover on can damage it and voids the warranty.
210 or 211?
The numbers are one apart, but these are different boats: the earlier 211 CC is about a foot shorter and roughly five inches narrower, with a bay-style layout of casting platforms fore and aft. Check the model on your hull paperwork; if it reads 211, choose the Everglades 211 T-Top cover instead.
Fabric, Warranty & Shipping
Choose 9oz solution-dyed marine fabric for heavy-duty everyday protection (5–7 year service life), a lighter 7oz fabric for budget-friendly coverage, or premium Sunbrella acrylic for 8–10 years of fade resistance. Every option is water-repellent, breathable, mildew-resistant, and double-stitched at the seams. Each cover is backed by our warranty (1 year on materials and workmanship, plus 3–6 years on the fabric) and ships for a $30 flat rate within the US — every cover is made to order, so please allow 1–3 weeks. For the 22-foot model, see the Everglades 223 T-Top cover.
