Everglades 211 T-Top Boat Cover — Custom-Fit for the Everglades 211 CC Bay-Style Console
Everglades Boats builds in Edgewater, Florida; it was founded in 1997 by Bob Dougherty, the former Boston Whaler designer who had earlier started EdgeWater, and it molds every hull with its patented RAMCAP process, which bonds the fiberglass hull and liner around a pre-molded closed-cell urethane foam core. The 211 CC is one of the early Everglades center consoles — listings we found run from 2004 to 2008 boats — and Soundings reports it was replaced by the 210 CC for 2007. Listings put it at about 20’7″ overall with a beam of roughly 8 feet (8’1″ on the factory sheet), a 16-inch draft and about 2,225 lb dry, and it carries 66 gallons of fuel on a 21-degree deadrise hull; the factory sheet lists Suzuki 175 and 250 outboards, and listed boats run 200 to 225 hp four-strokes. It’s laid out like a bay boat, with casting platforms fore and aft, and the fiberglass hardtop was optional, with spreader lights, an electronics box, 10 rod holders and a sliding windshield; a Bimini top was the alternative. The features a cover has to clear include the console with its heavy-duty windshield and grab rails, a combination helm seat/leaning post with a 40-gallon livewell, a 94-quart cooler seat with backrest at the console front, two flip-up aft seats, cockpit coaming bolsters and low-profile powder-coated bow rails. This T-Top cover is patterned for the 211 CC with its hardtop, and like all of our Everglades boat covers, it’s cut to this hull rather than a generic 21-foot size chart.
How It Fits the 211
The cover runs up to the underside of the hardtop and wraps its supports, leaving the roof and its rod holders exposed. Below, it drapes over the windshield, console and leaning post, carries forward over the cooler seat and the bow casting platform with its low rails, and falls to the rubrail along the narrow beam. Aft, it covers the flip-up seats and aft casting platform and encloses the outboard in the same piece. Installation takes about five minutes: drape it bow to stern, run the hem cord along the rubrail, and cinch the adjustable strap-and-buckle tie-downs. It’s made for storage on a trailer, lift, dry stack, or jet dock — take it off before towing, since trailering with the cover on can damage it and voids the warranty.
Not the Same as the 210
The 210 CC that followed is a bigger boat — 21’7″ on an 8’6″ beam with 95 gallons of fuel — and its deck is laid out differently, so the two take separate patterns. Check the model on your hull paperwork before ordering.
Fabric, Warranty & Shipping
Choose 9oz solution-dyed marine fabric for heavy-duty everyday protection (5–7 year service life), a lighter 7oz fabric for budget-friendly coverage, or premium Sunbrella acrylic for 8–10 years of fade resistance. Every option is water-repellent, breathable, mildew-resistant, and double-stitched at the seams. Each cover is backed by our warranty (1 year on materials and workmanship, plus 3–6 years on the fabric) and ships for a $30 flat rate within the US — every cover is made to order, so please allow 1–3 weeks. For the model that replaced it, see the Everglades 210 T-Top cover; for the 22-foot bay model, the Everglades 223 T-Top cover.
